LIQUID NAILS GLUE is a special glue used to bond various beauty series artificial nails. It can also be used to bond ceramics, toys, wood, leather and other materials. So do you know how to use it? Let’s take a look at it briefly!

Preparation tools: sponge file, dust brush, sand strip, cotton sheet, cotton, orange stick, nail lamp, 75° alcohol, 95° alcohol, primer, nail polish, and seal.

1. Polish the nail surface

1. Polish the nail surface with the rough surface of the sponge file in the order of the side.

2. Polish the front nail surface.

3. Polish the nail surface on the side surface again. When polishing the side surface, you need to use your fingers to slightly poke the outer skin of the nail before polishing.

Second, clean the nail surface

1. Use a dust brush to remove dust on the nail surface and nail groove.

2. Dip a cotton piece with 75° alcohol to wipe the nail surface.

Three, edging and primer coating

1. Wrap: First wrap the front edge of the nail with primer, that is, brush from one side of the front edge to the other, and then do it again in the opposite direction.

2. Apply primer: Follow the direction of your fingertips and apply a thin layer of primer.

3. Light curing.

Four, coloring glue

1. Apply the first layer of color: similarly, wrap the front edge with nail polish.

2. Apply a thin layer of nail polish from the back edge of the nail to the fingertips. When brushing the rear edge, gently press the brush head on the nail surface, slowly push it toward the edge of the finger to a distance of 0.5mm, and then pull it back.

3. Then brush both sides.

4. If applied to the skin, use orange sticks to roll up cotton to clean the nail margins.

5. Illumination.

6. Repeat the coloring and lighting, the method is the same as above (1-9).

Five, coating layer

1. Use a sealing layer to wrap the front edge.

2. Follow the direction of your fingertips and apply a thin layer of sealant.

3. If it is applied to the skin, use an orange stick to roll up cotton to clean the nail margins.

4. Light curing.

5. Remove the floating glue: If you use the scrubbing seal, the floating glue will be generated after the lamp is illuminated. You need to use a cotton piece to dip it in 95° alcohol to wipe it off.

6, complete

Six, completion effect

The color should be 0.5mm away from the nail edge, the color should be uniform, and the edge should be covered.

The above is an introduction to how to use LIQUID NAILS GLUE. If you want to dry as soon as possible, you can also rinse off the nail polish. After a minute or so, you can rinse the nail polish in clear water, because the water on the nail polish will evaporate and it will also speed up the drying of the nail polish. Or a hair dryer with cold air. When it’s too late, there is usually a hair dryer at home. At this time, you can use the cold air of the hair dryer to blow on the applied nail polish. Remember not to increase the cold air, which will blow the nail polish unevenly, and do not blow the hot air. Instead, it was slower for longer.