1
scroll down

How to use THREADLOCKER ADHESIVE?

Release time：

2021-01-27 11:46

Source：

THREADLOCKER ADHESIVE is suitable for all kinds of metals, even without the use of activators, it is excellent for active metals and inert substrates. Can be used on active surfaces: such as iron, copper, brass, steel, etc. Can also be used on inert surfaces: such as stainless steel, aluminum, gold-plated surfaces, etc. It has a heat resistance of 180°C, which enhances the reliability of high temperature applications. Do you know how to use THREADLOCKER ADHESIVE? Let's take a look at the sequential steps of THREADLOCKER ADHESIVE: surface treatment, sizing, installation, curing and finishing.

1. Surface treatment is to clean the surface of the adherend, remove rust and oil, polish properly, and clean and dry. For inactive, non-metallic surface coating accelerator. It is not suitable to use gasoline, fuel oil, etc., because they will leave a layer of oil film on the surface. The usual degreasing method is better to wash twice with solvent gasoline. The surface of the adherend is properly polished to improve the bonding strength. For the bonding of non-metallic surfaces, an accelerator should be applied. It is better to apply an accelerator on one side. After drying for 3min-5min, apply glue.

2. Sizing: Use the original packaging to directly apply THREADLOCKER ADHESIVE on the surface to be adhered, or brush or scrape it slightly. The appearance of the two adherends is coated with glue. A full surface can be painted and then installed to achieve a satisfactory effect. About THREADLOCKER ADHESIVE can only be applied to the bolt end and threaded mouth. When tightening, the glue will fill the entire gap. If it is a crack or a part that is not convenient to disassemble, you can also use the method of leaking glue. Glue is appropriate to fill the gap.

3. During installation, the parts should be rolled back and forth to spread the glue, and the parts should be positioned quickly. If an accelerator is used, the orientation can only be adjusted within the operable time (1min-5min).

4. The parts installed after sizing are usually cured at room temperature (5min-20min). Generally, the larger the bonding area and the smaller the gap, the faster the curing (same material). After curing for 3H, the bonding strength can reach 50%-65% of the extra value, and 24H can reach a larger value. As the temperature increases, the curing time is shortened and the bonding strength increases. At low temperatures (5 degrees Celsius -10 degrees Celsius), it is difficult to reach extra strength by extending 48H at the time of curing.

Surface treatment, sizing, installation, curing and finishing are the processes that must be passed through the use of THREADLOCKER ADHESIVE, but if there is no problem with the use of THREADLOCKER ADHESIVE, you must pay attention to the work in several processes. If you have problems with bonding, you need to find out if that link is not done well.

In summary, this is the story: you can learn more about the use of THREADLOCKER ADHESIVE and its process knowledge.

 

*Note：We will get in touch with you as soon as possible

message

Previous page

ANTI-MOLD MS GLUE tells the principle and precautions of glue?

What are the characteristics of DY-STRONG INSTANT GLUE and how to use it in construction?

Next

Related News

Questions and answers about MODIFIED ACRYLIC AB ADHESIVE (BOXES)

MODIFIED ACRYLIC AB ADHESIVE (BOXES) uses methyl methacrylate as the main raw material, with tougheners, reinforcing agents, stabilizers, initiators, polymerization inhibitors, etc., two components synthesized through advanced technology (A, B) Reactive structural adhesive.