How to use MODIFIED ACRYLIC AB ADHESIVE (BOXES)


MODIFIED ACRYLIC AB ADHESIVE (BOXES) is an AB glue that can stick plastic and iron, especially for common plastics such as PVC, ABS, PC, PS and iron, and it can be completed in 5-8 minutes at room temperature (25 degrees) Positioning and bonding can be completed in 2-3 minutes when the temperature is high, and it only takes four or five hours to reach the use strength. After curing, it has excellent acid and alkali resistance, salt spray resistance, solvent resistance, waterproof and oil resistance, etc. It is not available in resin glue and instant glue used for bonding plastic and iron. The sealing effect is also good. It can withstand vibration and impact. After it is fully cured, it can reach the strength of destroying plastic without degumming. It is suitable for a variety of plastic and iron bonding craft.

MODIFIED ACRYLIC AB ADHESIVE (BOXES)

MODIFIED ACRYLIC AB ADHESIVE (BOXES) has two commonly used operation methods for plastic and iron bonding: one is manual operation, that is, take an appropriate amount of MODIFIED ACRYLIC AB ADHESIVE (BOXES) in a weight ratio of 1:1 and mix them evenly Finally (one-time glue should not exceed 100 grams), apply it to one of the surfaces. When the size of the bonding surface is different, apply it to a small area of plastic or metal surface, compact it immediately, and try to make a rotation fit when bonding. , 3-5 minutes to complete the initial solidification;

Another common operation method is to use A+B tubular packaging and use special tools to beat MODIFIED ACRYLIC AB ADHESIVE (BOXES) to the surface of the plastic or iron to be bonded, and then complete the bonding;

Pay attention when using MODIFIED ACRYLIC AB ADHESIVE (BOXES) to bond plastic and iron:

1. Before use, remove dust, oil stains, anti-rust oil, rust, release agent and other stains on the surface of plastic and iron to ensure that the surface of plastic and iron is clean and dry.

2. After the bonding is completed, if conditions permit, pressurize for 1-2 hours, the effect is better, the usable strength can be reached in 4-5 hours, and the high strength can be reached in 24 hours.

3. When using A+B tubular packaging, it is recommended not to use a small amount of MODIFIED ACRYLIC AB ADHESIVE (BOXES) glue that has just been printed, because the glue in the first section is unevenly mixed.

*Note:We will get in touch with you as soon as possible

message

Related News


Questions and answers about MODIFIED ACRYLIC AB ADHESIVE (BOXES)

MODIFIED ACRYLIC AB ADHESIVE (BOXES) uses methyl methacrylate as the main raw material, with tougheners, reinforcing agents, stabilizers, initiators, polymerization inhibitors, etc., two components synthesized through advanced technology (A, B) Reactive structural adhesive.